Effect of groundwater forced seepage on heat transfer characteristics of borehole heat exchangers

Geothermal Energy

Jiuchen Ma¹  Yahui Wang²  Qian Jiang²  Qiuli Zhang²  Yacheng Xie²  Feiyu Yi² 

[1] School of Energy Safety Engineering, Tianjin Chengjian University, 300384, Tianjin, China;Key Laboratory for Efficient Use of Low and Medium Grade Energy, Ministry of Education of China, Tianjin University, 30072, Tianjin, China;Research Center for Efficient Utilization Technology of Geothermal Energy, Tianjin Chengjian University, 300384, Tianjin, China;School of Energy Safety Engineering, Tianjin Chengjian University, 300384, Tianjin, China;Research Center for Efficient Utilization Technology of Geothermal Energy, Tianjin Chengjian University, 300384, Tianjin, China;

关键词: Borehole heat exchangers;    Groundwater forced seepage;    Analytical solution;    Laboratory experiment;    Numerical simulation;    Pumping–injection well;   

DOI  :  10.1186/s40517-021-00192-1

来源: Springer

【 摘 要 】

A system of borehole heat exchangers (BHEs) combined with pumping–injection wells is established in areas where the groundwater is shallow and the seepage velocity is weak. The pumping and injection wells are set on both sides of the BHEs. According to the three-dimensional unsteady-state heat transfer model in the aquifer, the convection–dispersion analytical solution of excess temperature is derived that considers groundwater-forced seepage and thermal dispersion effects and axial effect of the BHEs. Then, we use the dimensional analysis method and similarity criteria to build a controllable forced seepage sandbox. The software FEFLOW 7.1 is adopted and the simulation results are validated by the theoretical analysis and the indoor experiment test. On this basis, the numerical simulation is used to explore the influence of different pumping–injection flow volume on the Darcy flow velocity of the aquifer where the BHEs are located, as well as the average heat transfer efficiency and the heat transfer rates with borehole depth. The results show that when the pumping flow volume increases from 200 m3 day−1 to 1200 m3 day−1, the Darcy velocity correspondingly increases to about 10 times. The average heat efficiency coefficient of the BHEs is increased by 11.5% in cooling stage, and by 7.5% in heating stage. When the pumping–injection flow volume is 400–600 m3 day−1, the increment of heat transfer rates of the BHEs reaches 12.8–17.9 W m−1 and 3.6–4.2 W m−1 per unit of borehole depth during the cooling stage and heating stage, respectively, and then decreases as the flow volume increases gradually.

【 授权许可】

CC BY