Effects of operating parameters in sweeping gas membrane distillation process: Numerical simulation of Persian Gulf seawater desalination

Journal of Water and Environmental Nanotechnology

ARTICLE

Asghari, Morteza¹  Dehghani, Mostafa¹  Riasat Harami, Hossein¹  Mohammadi, Amir Hossein³ 

[1] Separation Processes Research Group (SPRG), Department of Engineering, University of Kashan;Energy Research Institute, University of Kashan;Institut de Recherche en Génie Chimiqueet Pétrolier (IRGCP);Discipline of Chemical Engineering, School of Engineering, University of KwaZulu-Natal, Howard College Campus

关键词: Distillate flux;    numerical simulation;    Seawater;    Sweeping gas membrane distillation (SGMD);    Temperature polarization;   

DOI  :  10.22090/jwent.2018.02.004

学科分类：数学（综合）

来源: Iranian Environmental Mutagen Society

【 摘 要 】

In this communication, an advanced, simultaneous mass and heat transfer model has been developed to take a meticulous glance on the influences of different parameters on Persian Gulf seawater desalination using Sweeping Gas Membrane Distillation (SGMD) technique. This essay focuses on the increasing the distillate flux by investigation of the physical properties and feed temperature of the sweeping gas membrane distillation on the seawater desalination. The effects of operating parameters, including feed temperature, salt concentration, sweeping gas temperature, and heat transfer coefficient on the distillate flux of the Persian Gulf seawater have been investigated. The effect of feed temperature on temperature polarization has also been studied. By increasing the feed temperature from 25 o C to 60 o C, the temperature polarization increases and the polarization coefficient (TPC) decreases; for instance, for membranes with PP, the TPC decreases from 0.95 to 0.905. By increasing the feed temperature, higher fluxes are achieved for both the gas velocities. Therefore, by increasing the feed temperature from 50 o C up to 80 o C, the distillate flux grows 9 times. Also, the distillate flux for membrane with PVDF as polymer increased from 0 to 4.2 by increasing the feed temperature from 40 o C to 70 o C. The model predictions show a small error of 3.6% with the experimental data reported in literature which indicates the reliability of simulated results.

【 授权许可】

CC BY