Operating Conditions of Coagulation-Flocculation Process for High Turbidity Ceramic Wastewater

Journal of Water and Environmental Nanotechnology

ARTICLE

Al-Asheh, Sameer¹  Aidan, Ahmed¹ 

[1] Department of Chemical Engineering, American University of Sharjah

关键词: Ceramic Waste Water;    Coagulation;    Factorial Design;    Flocculation;    Turbidity;   

DOI  :  10.22090/jwent.2017.02.002

学科分类：数学（综合）

来源: Iranian Environmental Mutagen Society

【 摘 要 】

This work attempted to determine the optimum conditions required for the coagulation and flocculation process as an essential stage of the ceramic wastewater treatment. Coagulation and flocculation is a very necessary step in industries as it lessens turbidity, color, and odor of wastewater. The experimental work was performed in several runs. The volume of wastewater used in each run was 200 mL and was kept at this value throughout. In certain runs, the speed of the mixer was varied while keeping the quantity of coagulant and flocculant constant in order to determine the optimum speed that resulted in the least turbidity. A speed of 5% was chosen as the ideal process speed according to the results obtained. Next, experiments were operated at this optimum speed while changing the dosage of coagulant and flocculant in order to decide the optimum dosage. Coagulant and flocculent amounts of 0.4 g (without booster) and 0.2 g (with booster) selected after the readings were taken. For all the readings, a turbidity meter was used providing results in Nephelometric Turbidity Units (NTU). Lowest turbidity was achieved when using 5% speed with 0.4 grams of coagulant and 0.4 grams of flocculant, or 5% speed with 0.2 grams of coagulant, 0.2 grams of flocculant and 0.25 g/L of booster coagulant. According to factorial design analysis, such as parameters as impeller speed and dosage have an influential impact on the turbidity; while the booster has insignificant influence and other interactions between parameters are important.

【 授权许可】

CC BY