Influence of acid etching on shear strength of different glass ionomer cements

Brazilian Journal of Oral Sciences

Carolina Carvalho Bortoletto¹  Walter Gomes Miranda Junior²  Lara Jansiski Motta¹  Sandra Kalil Bussadori¹ 

[1] ,University of São Paulo School of Dentistry Department of Dental MaterialSão Paulo SP ,Brazil

关键词: glass ionomer cement;    shear strength;    dentin;   

DOI  :  10.1590/S1677-32252013000100003

来源: SciELO

【 摘 要 】

AIM: To assess the influence of dental etching on the shear strength of different glass ionomer cements. METHODS: The crown of 60 bovine incisors was prepared to obtain a flat, smooth surface, were attached to a PVC tube and randomly divided into six groups: Group 1 - Riva Self Cure without etching; Group II - Riva Self Cure with pre-etching; Group III - Maxxion R without etching; Group IV - Maxxion R with pre-etching; Group V - KetacTM Molar Easymix without etching; and Group VI - KetacTM Molar Easymix with pre-etching. Etching was performed with 10% polyacrylic acid for 30 s. A standardizing device was used for preparation of the test specimens (SBS Test Method). Following preparation, the specimens were stored in distilled water at 37° C for 24 h. The shear test was performed on a Kratos universal testing machine at a crosshead speed of 0.5 mm/min. The specimens were then viewed under a stereomicroscope at a magnification of x90 for analysis of fractures. RESULTS: The results revealed that pre-etching increased the shear strength of Riva glass ionomer cement (SDI) alone, whereas no statistically significant differences were found with regard to the other materials tested. CONCLUSIONS: Pre-etching with 10% polyacrylic acid for 30 s increased the shear strength of Riva glass ionomer cement.

【 授权许可】

CC BY   
 All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License