Analysis of Dimension Stone Waste Addition to the Clayey Mass Used in Roof Tile Production

Materials Research

Alessandra Savazzini Dos Reis¹  Viviana Possamai Della-sagrillo¹  Francisco Rolando Valenzuela-diaz¹ 

关键词: waste;    dimension stones waste;    structural ceramic;    ceramic roof tile;   

DOI  :  10.1590/1516-1439.346714

来源: SciELO

【 摘 要 】

Addition of dimension stone waste to clayey mass is an alternative to make the dimension stone sector more environmentally sustainable and to reduce the consumption of clayey raw material. Our aim is to study the technical feasibility of dimension stone waste addition to the clayey mass used in roof tile production. Samples of waste and clay were tested for physical, chemical, mineralogical and microstructural characterization. Samples containing dimension stone waste contents, varying from 10% to 90% (wt.), were produced and burned in industrial furnace of a structural ceramic factory at a 900°C maximum temperature for 24 hours. The technological characteristics evaluated were water absorption, apparent porosity, apparent density, loss on ignition, linear shrinkage and flexural strength. The results show that the samples with up to 60% waste content can be used in the production of ceramic bodies, since the waste promoted the physical packing of the grains, which increased the densification of ceramic bodies. With that, the waste-improved ceramic characteristics were analyzed. From 60% content onwards, the waste was not be able to fill the remaining interstices between the clay grains to densify the ceramic body because both raw materials have similar particle size distribution. Furthermore, the excess silica, in the form of quartz contained in the waste, presents an inert behavior in the factory firing temperature used in this research, causing fracture points and decreasing the flexural strength.

【 授权许可】

CC BY   
 All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License