Workability studies on cold upsetting of sintered copper alloy preforms

Materials Research

Ananthanarayanan Rajeshkannan¹ 

[1] ,The University of the South Pacific Faculty of Science, Technology and Environment School of Engineering and PhysicsSuva,Fiji

关键词: workability;    stress formability index;    stresses;    strains;   

DOI  :  10.1590/S1516-14392010000400006

来源: SciELO

【 摘 要 】

The major concern of the design for manufacturability is to accomplish the require deformation without failure of work material. The degree of deformation that can be achieved in a particular metal forming process without creating condition is termed as workability. The present investigation pertains to study the cold workability behaviour of Cu-7%Al-1.8%Si sintered preforms. Cold upsetting of these preforms with various aspect ratios were carried out and the working behaviour of the preforms at various stress state conditions was computed. The analysis measured for different components such as stress formability index and obtained density during secondary deformation as a function of induced strain. Similarly various computed stress ratio parameters with induced strain.

【 授权许可】

CC BY   
 All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License