Surface detail reproduction and dimensional accuracy of stone models: influence of disinfectant solutions and alginate impression materials

Brazilian Dental Journal

Ricardo Danil Guiraldo²  Thaís Teixeira Borsato²  Sandrine Bittencourt Berger²  Murilo Baena Lopes²  Alcides Gonini-jr²  Mário Alexandre Coelho Sinhoreti¹ 

[1] ,University North of Parana Dental School Department of Restorative DentistryLondrina PR ,Brazil

关键词: surface detail reproduction;    dimensional accuracy;    disinfectant solution;    alginate;   

DOI  :  10.1590/S0103-64402012000400018

来源: SciELO

【 摘 要 】

This study compared the surface detail reproduction and dimensional accuracy of stone models obtained from molds disinfected with 2% sodium hypochlorite, 2% chlorhexidine digluconate or 0.2% peracetic acid to models produced using molds which were not disinfected, with 3 alginate materials (Cavex ColorChange, Hydrogum 5 and Jeltrate Plus). The molds were prepared over matrix containing 20-, 50-, and 75-µm lines, performed under pressure with perforated metal tray. The molds were removed following gelation and either disinfected (using one of the solutions by spraying followed by storage in closed jars for 15 min) or not disinfected. The samples were divided into 12 groups (n=5). Molds were filled with dental gypsum Durone IV and 1 h after the start of the stone mixing the models were separated from the tray. Surface detail reproduction and dimensional accuracy were evaluated using optical microscopy on the 50-µm line with 25 mm in length, in accordance with the ISO 1563 standard. The dimensional accuracy results (%) were subjected to ANOVA. The 50 µm-line was completely reproduced by all alginate impression materials regardless of the disinfection procedure. There was no statistically significant difference in the mean values of dimensional accuracy in combinations between disinfectant procedure and alginate impression material (p=0.2130) or for independent factors. The disinfectant solutions and alginate materials used in this study are no factors of choice regarding the surface detail reproduction and dimensional accuracy of stone models.

【 授权许可】

CC BY   
 All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License