Handling sticky Resin by Stingless Bees: Adhesive Properties of Surface Structures

Anais da Academia Brasileira de Ciências

Markus Gastauer¹  Lucio A.o. Campos¹  Dieter Wittmann¹ 

关键词: measuring adhesion forces;    scanning electron microscopy;    surface properties;    cuticle;    ultrastructure;    medir forças de adesão;    microscopia eletrônica de varredura;    propriedades de superfície;    cutícula;    ultraestrutura;   

DOI  :  10.1590/S0001-37652013000300018

来源: SciELO

【 摘 要 】

Many Stingless Bees (Hymenoptera: Meliponini) like Tetragonisca angustula collect resin to defend their nests against intruders like ants or Robber Bees. Small portions of resin are attached to intruders bodies and extremities causing their immobilization. It has been observed that resin is removed easily from the bee's mandible but adheres strongly to the intruder's cuticle. We tested the hypothesis that resin sticks lesser to the mandibles of Stingless Bees than to the surface of intruders due to special surface structures or adhesive properties of these structures. The surface structures of the mandible of T. angustula and the trochanter of Camponotus sericeiventris were studied by scanning electron microscopy. To measure adhesion properties, selected surfaces were fixed on a fine glass pin and withdrawn from a glass tip covered with resin. The deformation of the glass pin indicates adhesion forces operating between the resin and the selective surface. The absolute value of the forces is computed from the glass pin's stiffness. It has been shown that resin sticks more to the smooth mandible of the bee than to the structured trochanter of the ant. A new hypothesis to be tested says that the bees might lubricate their mandibles with nectar or honey to reduce the resin's adhesion temporarily.

【 授权许可】

CC BY   
 All the contents of this journal, except where otherwise noted, is licensed under a Creative Commons Attribution License