3-D Modeling of Tomato Canopies Using a High-Resolution Portable Scanning Lidar for Extracting Structural Information

Sensors

Fumiki Hosoi²  Kazushige Nakabayashi¹ 

[1] Department of Agricultural Chemistry, Meiji University, 1-1-1, Higashi-mita, Tama-ku, Kawasaki-shi, Kanagawa 214-8571, Japan; E-Mail:;Graduate School of Agricultural and Life Sciences, The University of Tokyo, 1-1-1, Yayoi, Bunkyo-ku, Tokyo 113-8657, Japan; E-Mail:

关键词: canopy;    crop;    polygon;    portable scanning lidar;    3-D;    leaf area density;    leaf area index;   

DOI  :  10.3390/s110202166

来源: mdpi

【 摘 要 】

In the present study, an attempt was made to produce a precise 3D image of a tomato canopy using a portable high-resolution scanning lidar. The tomato canopy was scanned by the lidar from three positions surrounding it. Through the scanning, the point cloud data of the canopy were obtained and they were co-registered. Then, points corresponding to leaves were extracted and converted into polygon images. From the polygon images, leaf areas were accurately estimated with a mean absolute percent error of 4.6%. Vertical profile of leaf area density (LAD) and leaf area index (LAI) could be also estimated by summing up each leaf area derived from the polygon images. Leaf inclination angle could be also estimated from the 3-D polygon image. It was shown that leaf inclination angles had different values at each part of a leaf.

【 授权许可】

CC BY   
© 2011 by the authors; licensee MDPI, Basel, Switzerland.