Determination of the Shear Buckling Load of a Large Polymer Composite I-Section Using Strain and Displacement Sensors

Sensors

Jin Y. Park¹ 

[1] Mechanical Engineering, Minnesota State University, Mankato, MN 56001, USA; E-Mail:

关键词: strain sensor;    displacement sensor;    shear buckling;    polymer composite I-section;    asymmetric loading;   

DOI  :  10.3390/s121216024

来源: mdpi

【 摘 要 】

This paper presents a method and procedure of sensing and determining critical shear buckling load and corresponding deformations of a comparably large composite I-section using strain rosettes and displacement sensors. The tested specimen was a pultruded composite beam made of vinyl ester resin, E-glass and carbon fibers. Various coupon tests were performed before the shear buckling test to obtain fundamental material properties of the I-section. In order to sensitively detect shear buckling of the tested I-section, twenty strain rosettes and eight displacement sensors were applied and attached on the web and flange surfaces. An asymmetric four-point bending loading scheme was utilized for the test. The loading scheme resulted a high shear and almost zero moment condition at the center of the web panel. The web shear buckling load was determined after analyzing the obtained test data from strain rosettes and displacement sensors. Finite element analysis was also performed to verify the experimental results and to support the discussed experimental approach.

【 授权许可】

CC BY   
© 2012 by the authors; licensee MDPI, Basel, Switzerland