Effects of Design/Operating Parameters and Physical Properties on Slag Thickness and Heat Transfer during Coal Gasification

Energies

Insoo Ye²  Junho Oh²  Changkook Ryu¹ 

[1] School of Mechanical Engineering, Sungkyunkwan University, Suwon 440-746, Korea;

关键词: ash deposition;    coal gasification;    heat transfer;    slag flow;    syngas;   

DOI  :  10.3390/en8053370

来源: mdpi

【 摘 要 】

The behaviors of the slag layers formed by the deposition of molten ash onto the wall are important for the operation of entrained coal gasifiers. In this study, the effects of design/operation parameters and slag properties on the slag behaviors were assessed in a commercial coal gasifier using numerical modeling. The parameters influenced the slag behaviors through mechanisms interrelated to the heat transfer, temperature, velocity, and viscosity of the slag layers. The velocity profile of the liquid slag was less sensitive to the variations in the parameters. Therefore, the change in the liquid slag thickness was typically smaller than that of the solid slag. The gas temperature was the most influential factor, because of its dominant effect on the radiative heat transfer to the slag layer. The solid slag thickness exponentially increased with higher gas temperatures. The influence of the ash deposition rate was diminished by the high-velocity region developed near the liquid slag surface. The slag viscosity significantly influenced the solid slag thickness through the corresponding changes in the critical temperature and the temperature gradient (heat flux). For the bottom cone of the gasifier, steeper angles were favorable in reducing the thickness of the slag layers.

【 授权许可】

CC BY   
© 2015 by the authors; licensee MDPI, Basel, Switzerland.