Formulating Fine to Medium Sand Erosion for Suspended Sediment Transport Models

Journal of Marine Science and Engineering

François Dufois¹  Pierre Le Hir¹ 

[1] Laboratoire DYNECO/PHYSED, IFREMER, BP70, 29280 Plouzané, France; E-Mail:

关键词: sand;    1DV model;    erosion rate;    suspended sediment transport;   

DOI  :  10.3390/jmse3030906

来源: mdpi

【 摘 要 】

The capacity of an advection/diffusion model to predict sand transport under varying wave and current conditions is evaluated. The horizontal sand transport rate is computed by vertical integration of the suspended sediment flux. A correction procedure for the near-bed concentration is proposed so that model results are independent of the vertical resolution. The method can thus be implemented in regional models with operational applications. Simulating equilibrium sand transport rates, when erosion and deposition are balanced, requires a new empirical erosion law that involves the non-dimensional excess shear stress and a parameter that depends on the size of the sand grain. Comparison with several datasets and sediment transport formulae demonstrated the model’s capacity to simulate sand transport rates for a large range of current and wave conditions and sand diameters in the range 100–500 μm. Measured transport rates were predicted within a factor two in 67% of cases with current only and in 35% of cases with both waves and current. In comparison with the results obtained by Camenen and Larroudé (2003), who provided the same indicators for several practical transport rate formulations (whose means are respectively 72% and 37%), the proposed approach gives reasonable results. Before fitting a new erosion law to our model, classical erosion rate formulations were tested but led to poor comparisons with expected sediment transport rates. We suggest that classical erosion laws should be used with care in advection/diffusion models similar to ours, and that at least a full validation procedure for transport rates involving a range of sand diameters and hydrodynamic conditions should be carried out.

【 授权许可】

CC BY   
© 2015 by the authors; licensee MDPI, Basel, Switzerland.