Characterization of a Three Wavelength Photoacoustic Soot Spectrometer (PASS-3) and a Photoacoustic Extinctiometer (PAX)

Journal of the Meteorological Society of Japan. Ser. II

Akihiro UCHIYAMA¹  Satomi KAGAMITANI²  Yutaka MATSUMI²  Tomoki NAKAYAMA²  Hiroyuki SUZUKI²  Yuka IKEDA² 

[1] Meteorological Research Institute, Japan Meteorological Agency, Tsukuba, Japan;Solar-Terrestrial Environment Laboratory and Graduate School of Science, Nagoya University, Nagoya, Japan

关键词: photoacoustic spectrometer (PAS);    reciprocal nephelometer;    absorption coefficient;    scattering coefficient;    aerosol optical property;    calibration;   

DOI  :  10.2151/jmsj.2015-016

学科分类：大气科学

来源: Meteorological Society of Japan

【 摘 要 】

 Laboratory experiments were conducted for characterizing the performance of two commercially available instruments employed for the measurement of light absorption and scattering coefficients of aerosols at λ = 405, 532, and 781 nm (using three-wavelength photoacoustic soot spectrometer; PASS-3) as well as at 375 nm (using photoacoustic extinctiometer; PAX) based on photoacoustic spectroscopy and reciprocal nephelometry, respectively. The calibration factors (conversion factors from the readout to real values) associated with scattering measurements, estimated using gaseous molecules, mono-disperse polystyrene latex and ammonium sulfate particles, and/or poly-disperse ammonium sulfate particles, are in good agreement with one another, typically within 5 %, 5 %, and 10 % at 375, 405, and 781 nm, respectively. In contrast, a significant particle size dependency was observed for the calibration factors at 532 nm, which is possibly because of a combination of differences in the polarization states of the lasers relative to the scattering planes and large truncation angle. Considering the estimated effective truncation angle, the typical uncertainties in calibration factors for scattering when measuring non- or weakly light-absorbing particles, with volume-based geometrical diameters of less than 700 nm, were estimated to be 12 %, 7 %, 34 %, and 17 %, at 375, 405, 532, and 781 nm, respectively. The typical uncertainties in the calibration factors for absorption measurements, which were determined using poly-disperse propane soot particles, were estimated to be 6 %, 4 %, 8 %, and 11 %, at 375, 405, 532, and 781 nm, respectively. The calibration factors for absorption determined by the poly-disperse soot particles at 375 and 405 nm were 48 % and 36 % smaller than those by light absorption of NO2 molecules possibly because of NO2 photolysis, although good agreement was observed at 532 nm. These results suggest that the photolysis effect should be taken into account when light absorption by NO2 is used for calibration at 375 and 405 nm.

【 授权许可】

Unknown