Fabrication and Characterization of SiO2 Particles Generated by Spray Method for Standards Aerosol

JOURNAL OF CHEMICAL ENGINEERING OF JAPAN

I. WULED LENGGORO²  TAE OH KIM¹  MANABU SHIMADA²  NAOTO NAKAO²  KIKUO OKUYAMA²  FERRY ISKANDAR² 

[1] School of Architectural, Civil and Environment Engineering, Kumoh National University of Technology;Department of Chemical Engineering, Hiroshima University

关键词: Aerosol;    Calibration Particles;    Silica;    Light Scattering;    Electrical Mobility;   

DOI  :  10.1252/jcej.34.1285

来源: Maruzen Company Ltd

【 摘 要 】

References(12)Cited-By(22)This paper describes the investigation of the generation of spherical silica particles, which could potentially be used as alternative calibration aerosol for substituting DOP (dioctylphthalate) particles. Silica particles were generated by a spray drying method using a nanometer-sized colloidal silica suspension as the starting material. The generated silica particles have a spherical morphology, are nearly monodispersed and their size can be controlled at submicron order. The smoothness of the particle surface is greatly affected by the size of the colloidal silica particles used. Silica aerosol particles were also generated by the spray pyrolysis of an aqueous solution of tetraethylorthosilicate (TEOS), in order to compare their properties with those of silica particles obtained by spray drying method. The electrical mobility equivalent diameter of silica particles generated by spray drying method is in good agreement with the diameter determined by SEM observation. The light scattering characteristics of the silica aerosol particles were also measured using a laser particle counter and compared with a polystyrene latex (PSL) aerosol. By increasing the drying temperature of the silica sol droplets to 1200°C, the change of scattered light intensity with particle diameter shows a tendency similar to that of spherical PSL particles. Consequently, the spherical submicron silica particles generated by the present spray drying method appear to be applicable to the test of air filters.

【 授权许可】

Unknown