The study of corrosion stability of organic epoxy protective coatings on aluminium and modified aluminium surfaces

Journal of the Brazilian Chemical Society

IEC, Belgrade, Serbia and Montenegro¹  Drazic, Dragutin M.¹  Kacarevic-Popovic, Zorica¹  Lazarevic, Zorica Z.¹  Miškovic-Stankovic, Vesna B.¹  University of Belgrade, Belgrade, Serbia and Montenegro¹  Institute of Nuclear Science Vinca, Belgrade, Serbia and Montenegro¹ 

关键词: aluminium;    corrosion;    electrodeposition;    epoxy coatings;    EIS;   

DOI  :  10.1590/S0103-50532005000100015

学科分类：化学（综合）

来源: SciELO

【 摘 要 】

Epoxy coatings were formed by cathodic electrodeposition of an epoxy resin on aluminium and modified aluminium surfaces (phosphatized, chromatized-phosphatized and anodized aluminium) using a constant voltage method (resin concentration 10 wt.%, temperature 27 ºC, applied voltage 250 V). The corrosion behavior of these coatings was investigated during exposure to 3% NaCl using electrochemical impedance spectroscopy (EIS) and polarization measurements. From the dependence of resistance, capacitance and relative permittivity of the coating, obtained from EIS, on the rate of hydrogen evolution reaction in the electrodeposition bath, obtained from polarization curves, it can be observed that the epoxy coating on aluminium and modified aluminium surfaces is a good barrier against the transport of corrosive agents. The time corresponding to contact between electrolyte and aluminium surface under the coating is greater in the case of surface modification by chromato-phosphatized and anodized aluminium than in the case of phosphatize one.

【 授权许可】

Unknown