Avaliação da rugosidade superficial da madeira de Eucalyptus sp submetida ao fresamento periférico

CERNE

Lopes, Camila Santos Doubek¹  Tomazello Filho, Mário²  Nolasco, Adriana Maria²  Dias, Carlos Tadeu dos Santos² 

[1] Universidade Estadual de Londrina, Londrina, Brasil$$;Escola Superior de Agricultura Luiz de Queiroz, Piracicaba, Brasil$$

关键词: E. dunnii;    E. grandis;    E. urophylla;    Wood machinability;    Roughness surface.;   

DOI  :  10.1590/0104776020142003875

来源: Universidade Federal de Lavras-UFLA

【 摘 要 】

This work evaluated the quality of roughness surface of 18 years-old Eucalyptus grandis, E. dunnii and E. urophylla trees wood, to produce prepared 48 furniture. For the laboratory essays samples/species were prepared in the machining treatments in milling machine of vertical axis, in the up milling direction, in seven cut speeds (3 to 22 m.min^-1). In the evaluation of the surface quality of the wood samples it was used the surface profiling instrument Taylor Hobson model Surtronic 3+, using the filter 2CR, with sampling length of 0,80 Ie or ln (mm) and cut-off of 0,80 λc (mm). The results indicated that the E. urophylla wood presented the best surface quality and with the smallest values of variation coefficient; the E. grandis wood showed intermediate values and E. dunnii wood presented the worst performance, as well as the largest value of variation coefficient. It was observed, also, that the treatment effect for the three eucalyptus wood species was related with the machining speed; better in the 3-4 m.min^-1 and worse in the 22 m.min^-1. The surface quality of the machined wood was related to its density, with the eucalyptus species of denser wood presenting the best quality of machined surface.

【 授权许可】

Unknown