Optimization of process parameters for friction stir processing (FSP) of Al�?�TiC in situ composite

Bulletin of materials science

Ranjit Bauri¹ 

[1] Department of Metallurgical and Materials Engineering, Indian Institute of Technology Madras, Chennai 600 036, India$$Department of Metallurgical and Materials Engineering, Indian Institute of Technology Madras, Chennai 600 036, IndiaDepartment of Metallurgical and Materials Engineering, Indian Institute of Technology Madras, Chennai 600 036, India$$

关键词: In situ composites;    friction stir processing;    microstructure;    grain refinement;    mechanical properties.;   

DOI  :  

学科分类：材料工程

来源: Indian Academy of Sciences

【 摘 要 】

Segregation of in situ formed particles at the grain boundaries is a major drawback of in situ composites. In this study, it has been demonstrated that friction stir processing (FSP) can be used as an effective tool to homogenize the particle distribution in Al based in situ composites and FSP processing parameters were optimized for this purpose. An Al-5 wt% TiC composite was processed in situ using K₂TiF₆ and graphite in Al melt and subjected to FSP. Processing parameters for FSP were optimized to get a defect free stir zone and homogenize the particle distribution. It was found that a rotation speed > 800 rpm is needed. A rotation speed of 1000 rpm and a traverse speed of 60 mm/min were found to be an optimum combination. The grain size was also refined in addition to homogenization of the as-cast microstructure. This resulted in significant improvement in the mechanical properties of the processed composite.

【 授权许可】

Unknown