Microstructural characterization of the �?-TiAl alloy samples fabricated by direct laser fabrication rapid prototype technique

Bulletin of materials science

D Srivastava¹ 

[1] Materials Science Division, Bhabha Atomic Research Centre, Mumbai 400 085, India$$Materials Science Division, Bhabha Atomic Research Centre, Mumbai 400 085, IndiaMaterials Science Division, Bhabha Atomic Research Centre, Mumbai 400 085, India$$

关键词: Titanium aluminide;    microstructure;    direct laser fabrication;    rapid prototyping.;   

DOI  :  

学科分类：材料工程

来源: Indian Academy of Sciences

【 摘 要 】

A direct laser fabrication technique (DLF) has been used to fabricate near net shape samples of a ð›�?-TiAl alloy using gas atomized Ti₄₈A1₄₈Mn₂Nb₂ alloy powder as a feed stock material. The microstructures of these Ti₄₈Al₄₈Mn₂Nb₂ laser treated samples have been characterized using optical, scanning (SEM) and transmission electron microscopy (TEM), both immediately after laser fabrication and after heat treatments. The microstructural studies have shown that the microstructure is heterogeneous in nature and extremely fine in comparison with the conventionally processed material. The process parameters such as laser power and laser scanning speed greatly influence the morphology and the microstructure of the laser treated samples. Heat treatments for a number of process conditions have been carried out to examine the stability of the microstructure which remains stable up to 973 K and rapid grain coarsening occurs at 1273 K. A fully recrystallized and uniform microstructure is obtained after annealing at 1073 K for 24 h and compositional heterogeneity present in the laser-fabricated samples is eliminated. Annealing in the ð›�? phase field followed by air cooling and annealing in (ð›�?₂ + ð›�?) phase region gives rise to a homogeneous and uniform microstructure. However, the microstructure is much coarser than the microstructure of the DLF samples.

【 授权许可】

Unknown