Marginal and internal fit of CAD/CAM and slip-cast made Zirconia copings

Journal of Dental Research, Dental Clinics, Dental Prospects

Leila Farahi¹  Ahmad Hassan Ahangari¹  Kianoosh Torabi Ardekani¹ 

关键词: CAD/CAM;    internal fit;    marginal fit;    slip-cast;   

DOI  :  

学科分类：农业科学（综合）

来源: Tabriz University of Medical Sciences * Faculty of Dentistry

【 摘 要 】

Background and aims. CAD/CAM systems facilitate the use of zirconia substructure materials for all-ceramic copings. This in vitro study investigated the marginal and internal fit of zirconia copings made with CAD/CAM system and slip-casting method.Materials and methods. Sixteen CAD/CAM made zirconia copings and 16 slip-cast made zirconia copings were fabricated and cemented with glass-ionomer cement to their respective master abutment models, and thickness of the cement layer was measured at specific measuring points with stereomicroscope.Results. In the left wall, the mean axial internal gap was greater in group one than group two (62.49 vs. 48.14) (P =0.007), in the right wall the mean axial internal gap was greater in group one than group two (44.87 vs. 40.91) (P = 0.465). The occlusal internal gap was greater in group one than group two (118.81 vs. 102.11) (P =0.423). The mean marginal gap also was greater in group one than group two (46.67 vs. 44.29) (P = 0.863). The differences in marginal fit between these two methods were not statistically significant, except for left axial internal gap that was significantly greater in the CAD/CAM system than conventional slip-cast technique (P =0.007).Conclusion. It was concluded that this CAD/CAM system can compete well with conventional systems for clinical fit, and can achieve good in vitro marginal fit.

【 授权许可】

Unknown