A COMPARISON OF THE TENSILE STRENGTH OF PLASTIC PARTS PRODUCED BY A FUSED DEPOSITION MODELING DEVICE

Acta Polytechnica

Juraj Beniak¹  Miloš Matúš¹  Peter Križan¹ 

[1] Slovak Univerzity of Technology in BratislaveFaculty of Mechanical Engineering

关键词: rapid Prototyping;    FDM;    Fused Deposition Modeling;    3D printer;    Additive manufacturing;   

DOI  :  

来源: Czech Technical University in Prague, Faculty of M

【 摘 要 】

Rapid Prototyping systems are nowadays increasingly used in many areas of industry, not only for producing design models but also for producing parts for final use. We need to know the properties of these parts. When we talk about the Fused Deposition Modeling (FDM) technique and FDM devices, there are many possible settings for devices and models which could influence the properties of a final part. In addition, devices based on the same principle may use different operational software for calculating the tool path, and this may have a major impact. The aim of this paper is to show the tensile strength value for parts produced from different materials on the Fused Deposition Modeling device when the horizontal orientation of the specimens is changed.

【 授权许可】

Unknown