First report of benzimidazole, DMI and QoI-insensitive Cercospora beticola in sugar beet in Morocco

New disease reports

S. Ezrari^1^3¹  A. Tahiri^1²  Z. El Housni^1^2³ 

[1] Department of Biology, Faculty of Sciences, Moulay Ismail University, PO Box 11201, Zitoune, Meknès, Morocco^2;Laboratory of Functional Ecology and Environment, Sidi Mohamed Ben Abdellah University, PO Box 2202, Route d’Imouzzer, Fez, Morocco^3;Phytopathology Unit, Department of Plant Protection, Ecole Nationale d’Agriculture de Meknès, BPS 40, 50001, Meknès, Morocco^1

关键词: Cercospora leaf spot;    fungicide resistance;   

DOI  :  10.5197/j.2044-0588.2018.038.017

学科分类：生物科学（综合）

来源: British Society for Plant Pathology

【 摘 要 】

Sugar beet ( Beta vulgaris ) is one of most important industrial crops in Morocco. In 2016, the cultivated area exceeded 61,000 ha and it's anticipated that this area will increase to 77,500 ha by 2020. However, sugarbeet yield is often restricted by several diseases. Cercospora leaf spot, caused by Cercospora beticola , is of the major foliar diseases of sugar beet in Morocco. Its control mainly involves extensive use of fungicides such as benzimidazoles (thiophanate-methyl) and demethylation inhibitors (DMI) (difenoconazole, epoxiconazole and tetraconazole). To evaluate the sensitivity of C. beticola isolates to commonly used fungicides benzimidazole, DMI and QoI, symptomatic sugarbeet leaves were collected from the four major sugarbeet producing regions (Berkane, Doukala, Ghareb and Tadla) during the 2016-2017 growing season. Several isolates of the fungus were isolated from different regions and purified on potato dextrose agar (PDA) medium. To test their reactions to fungicides, the isolates were sub-cultured on Petri dishes containing PDA medium amended with different concentrations of thiophanate-methyl (1.5,10 and 50 ppm), difenoconazole, epoxyconazole and tetraconazole (0.1, 0.5, 1,5, 10, and 50 ppm), and azoxystrobine and trifloxistrobine (1, 5,10 and 50 ppm). Using the data collected from the in vitro tests, the mycelial inhibition rate with respect to the fungicidal concentration was calculated and the EC50 (effective control of 50% of mycelial growth) was recorded for each isolate. Twenty-two isolates were tested against fungicides with 5 ppm as a reference dose for thiophanate-methyl (Trkulja et al. , 2015), 1 ppm for tetraconazole and epoxiconazole (Bolton et al. , 2012), 0.05 ppm for difenoconazole (Karaoglanidis et al. , 2003) and 100 ppm for azoxistrobine (Piszczek et al. , 2018). The results showed that all isolates were resistant to thiophanate-methyl with an EC50 >5 ppm but with different levels of resistance (Fig. 1). Three groups were distinguished according to Trkulja et al. (2012); the first group had low resistance and an EC50 1000 ppm (63.63% of isolates). For difenoconazole 41% of isolates were sensitive and 59% were resistant while for tetraconazole and epoxiconazole 27.3% of isolates were resistant, 66.7% with medium resistance and 6% were sensitive (Fig. 2). Furthermore, the mycelial growth inhibition with QoI was less effective with azoxystrobine compared to that obtained with trifloxistrobine (Fig. 3). There were at least 54.54% of isolates which demonstrated resistance to azoxystrobine. This is the first report of benzimidazole-DMI and QoI-insensitive C. Beticola isolates in Morocco. This situation is of concern because more than 73% of the registered fungicides belong to these three groups, leaving the dithiocarbamate-based products the only effective tools for managing Cercospora leaf spot. In addition, the combination of two DMI applications and QoI or DMI/benzimidazole with a contact fungicide might be less effective as resistant Cercospora isolates are widespread in sugarbeet growing areas in Morocco.

【 授权许可】

CC BY