Releasing systems for aerospace industry based upon Shape Memory Alloys: characterization of materials for actuators

Materia

Soul, Hugo¹  Yawny, Alejandro²  Glücksberg, Andrés³ 

[1]Centro Atómico Bariloche, S. C. Bariloche, Argentina

[2]Consejo Nacional de Investigaciones Científicas y Técnicas, Buenos Aires, Argentina

[3]Instituto Balseiro, S. C. Bariloche, Argentina

关键词: Constrained Recovery;    SMA actuators;    NiTi;    Release systems.;   

DOI  :  10.1590/s1517-707620180002.0328

学科分类：工程和技术（综合）

来源: Universidade Federal do Rio de Janeiro * Coordenacao dos Programas de Pos-Graduacao de Engenharia

【 摘 要 】

Releasing and deployment maneuvers carried out during space satellites launching are usually performed by utilizing pyrotechnics loads. However, it is considered convenient to replace this technique by others not requiring explosives (Non Explosive Actuators-NEA). This is mainly due to the necessity of reducing high-shock and vibrations induced levels, also avoiding the contamination of sensible instruments because of dust and gas release during explosion. In addition, the avoidance of risks associated with storage and manipulation of explosives and the possibility of performing device retesting prior to final mounting are desirable qualities. Among NEA devices, those exploiting the singular mechanical behavior of Shape Memory Alloys (SMA) have reached commercial maturity. In this study, the performance of a NEA device that uses the mechanical stress generated upon reverse transformation of a mechanically constrained SMA actuator (constrained recovery effect) to generate the controlled fracture of a notched bolt is analyzed. Firstly, the mechanical components of the system are described, and the main problems associated with its design are introduced. Then, the results of the experimental characterization performed on a NiTi SMA cylindrical tube actuator with 12.7 and 7.8 mm outer and inner diameter respectively, are presented. After an activation stage in which the cylinder is compressed to induce the martensitic phase (or re-orient the existing martensític phase), the temperature is raised while a constant displacement condition is imposed. For temperatures near 120 ºC, a loads increment of 35 kN (440 MPa) is obtained. The repetition of this loading-unloading-heating-cooling cycle does not generate any important deterioration in the material response.

【 授权许可】

CC BY