Bending force of LLDPE monofilaments at high temperatures measured in DMA (Dynamic Mechanical Analyzer)

Aegean International Textile and Advanced Engineering Conference 2018

Kola, I.^1 ; Kolgjini, B.^1 ; Guxho, G.^1 ; Kiekens, Paul^2

Polytechnic University of Tirana, Faculty of Mechanical Engineering, Department of Textile and Fashion, Sheshi Nënë Tereza, Nr. 1, Tirana

AB, Albania^1

Ghent University, Department of Materials Textile and Chemical Engineering, Technologiepark 907, Zwijnaarde, Ghent

9052, Belgium^2

关键词: Air temperature;    Artificial turfs;    Bending behavior;    Dynamic mechanical analyzer;    Elevated temperature;    Entire system;    High temperature;    Linear density;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/459/1/012049/pdf
DOI  :  10.1088/1757-899X/459/1/012049

来源: IOP

【 摘 要 】

The bending force of monofilaments used as pile layer in artificial turf football fields is a very important property due to the strong relation with the performance of the entire system being the force that mostly influences the deformation of monofilaments. The existing test methods for measuring this force can only be used to perform tests at room temperature. Nowadays, artificial turf surfaces are being installed worldwide, even in regions with very high values of air temperature, leading to the need of evaluating the performance of monofilaments and thus, of testing their bending force at elevated temperatures. The aim of this paper is to use the DMA's advantage of testing at high temperatures, by using a new test method developed for measuring the bending force of monofilaments at room temperature and to evaluate the results obtained. For this purpose, six different LLDPE (Low Linear Density Polyethylene) monofilaments are tested at temperatures 25°C, 50°C and 80°C and the bending force is measured. The DMA is used successfully on performing tests at high temperatures. Considering the results, an analysis of the bending behavior of LLDPE monofilaments depending on the temperature is done. All fibers show the same trends regarding this influence, with decreasing of the bending force while increasing the temperature.