Three-dimensional simulation of a single pass hot rolling of carbon steel: Case of instabilities in steady state region

4th International Conference on Applied Materials and Manufacturing Technology

材料科学;机械制造

Musonda, V.^1,2 ; Akinlabi, E.T.^1

Department of Mechanical Engineering Science, University of Johannesburg, Auckland Park, Kingsway Campus, P.O. Box 524, Johannesburg

2006, South Africa^1

Department of Mechanical Engineering, School of Engineering, University of Zambia, Great East Rd. Campus, P.O. Box 32379, Lusaka, Zambia^2

关键词: Critical strains;    Finite element modelling;    Inhomogeneities;    Micro-structural properties;    Steady-state regions;    Steady-state rolling (SSR);    Three dimensional simulations;    Torque variations;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/423/1/012162/pdf
DOI  :  10.1088/1757-899X/423/1/012162

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

The nature of instabilities in the steady-state region in the form of high amplitudes or peaks during hot rolling can be an indication of the problems in the roll mill stand. The aim of this study is to predict the variation in load, stress, strain, torque and power and the influence these parameters can have during the deformation of the workpiece in the roll gap. To achieve this aim, finite element modelling (FEM) was used in the simulation of a single pass hot rolling of AISI 1016 carbon steel. The results indicate that, large amplitudes in the stresses, strains and torque variations can result in vibrations in the mill stands compared to the steady state point values. This can also result in inhomogeneity in the microstructural properties of the rolled workpiece. Inaccuracies in the geometry of the rolled products too may arise. Elastic deformation occurred during the critical strain ( c)until the peak strain( p) was reached after which steady state rolling (plastic deformation) commenced. Inhomogeneity in the rolled product also occurred during the reduction of the workpiece and this can lead to mill breakdowns. The results obtained are in agreement with the existing literature. Suggestions regarding improvement to the mills to optimise the process are also presented.