会议论文详细信息
International Deep Drawing Research Group 37th Annual Conference
Determination of forming limit for aluminium alloy sheet eliminating the interferences of through-thickness stress and non-linear strain path
Chen, Zhu^1,2 ; Fang, Gang^1,2
Department of Mechanical Engineering, Tsinghua University, Beijing
100084, China^1
State Key Lab of Tribology, Tsinghua University, Beijing
100084, China^2
关键词: Aluminium-alloy sheets;    Compensation method;    Forming limit diagrams;    In-plane stress;    Measurement accuracy;    Nonlinear strain;    Through thickness stress;    Ultimate strain;   
Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/418/1/012051/pdf
DOI  :  10.1088/1757-899X/418/1/012051
来源: IOP
PDF
【 摘 要 】

The accuracy of the forming limit diagram (FLD) determined through Nakazima test is often influenced by non-linear strain path (NLSP) and through-thickness stress. The influence of these factors on measurement accuracy can be weakened or avoided in Marciniak test. But meanwhile, Marciniak test is difficult in operation and possesses poor repeatability. Therefore, the Nakazima test eliminating the influencing factors of accuracy is still an attractive method due to the easy operability and good repeatability. In the present research, two FLDs of aluminium alloy 6014-T4 that were established through Nakazima and Marciniak tests were compared. In order to obtain an accurate FLD in plane-stress state and linear strain paths via Nakazima test, a modified compensation method was applied in Nakazima test to eliminate the interferences of NLSP and through-thickness stress on measuring forming limits. The ultimate strains measured in Nakazima test were transformed to stress-based forming limits through constitutive models to remove the influence of through-thickness stress. Then, the corrected ultimate stresses were transformed back to the limit strains along linear strain paths. Compensated results of Nakazima test showed a good agreement with the experimental results from Marciniak test, proving the validity of this method. Thus, through the easy-operate Nakazima test, an FLD with comparable accuracy to that based on Marciniak test was established.

【 预 览 】
附件列表
Files Size Format View
Determination of forming limit for aluminium alloy sheet eliminating the interferences of through-thickness stress and non-linear strain path 4427KB PDF download
  文献评价指标  
  下载次数:16次 浏览次数:33次