Investigations on the Characteristics of Thermally Sprayed NiCrBSi Coatings Fused by Flame and Inductive Processing

7th International Conference on Advanced Materials and Structures

Vlean, P.C.^1,2 ; Kazamer, N.^1,2 ; Muntean, R.^1 ; Pascal, D.T.^1 ; Kilic, Y.^1 ; Mrginean, G.^1 ; Serban, V.A.^2

Westphalian University of Applied Sciences, Neidenburger Str. 43, Gelsenkirchen

45897, Germany^1

Politehnica University Timisoara, Piaa Victoriei 2, Timioara

300006, Romania^2

关键词: Feedstock materials;    Hardfacing alloys;    Hardness distribution;    High-frequency current;    NiCrBSi coatings;    Oxyacetylene flame;    Self fluxing alloy;    Wear and corrosion resistance;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/416/1/012002/pdf
DOI  :  10.1088/1757-899X/416/1/012002

来源: IOP

【 摘 要 】

Ni-based materials are some of the most used hardfacing alloys to improve wear and corrosion resistance for parts functioning under severe conditions. For the current study, a NiCrBSi self-fluxing alloy powder with particle size in range of 45-106 μm was employed as feedstock material and deposited onto a steel substrate material using the oxyacetylene thermal spraying process. The as-sprayed components have been subsequently subjected to thermal post-processing in order to increase the adhesion to the substrate and to reduce the inherent porosity of the coatings. Consequently, two types of heating sources were chosen. One of them was the neutral oxyacetylene flame and the second one was based on high frequency currents. The aim of this work was to study the influence of the heat source type of the post treatment on the final characteristics of the coatings. Evaluation of the morphology and microstructure of the developed coatings was performed after the remelting process by means of scanning electron microscopy. Hardness tests were carried out in cross-section complying with the ASTM E384 standard. In both cases, after fusing, the microstructure was refined, with a drastic decrease in porosity. Evaluation of the hardness distribution along the coating cross-section revealed similar values of microhardness.