The Effect of Indentation Load, Tilted Angle, and the Amount of Surface Removal to the Fracture Toughness of Silicon Nitride Measured by the Surface Crack in Flexure (SCF) Test Method

6th International Conference on Nanomaterials and Materials Engineering

Nindhia, T.G.T.^1

Department of Mechanical Engineering, Engineering Faculty, Udayana University, Bali, Jimbaran, Indonesia^1

关键词: Advanced Ceramics;    Effect of measurements;    Experimental parameters;    Fracture toughness values;    Semi-elliptical surface cracks;    Serial sectioning;    Single-edge V-notched beams;    Surface crack in flexures;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/380/1/012006/pdf
DOI  :  10.1088/1757-899X/380/1/012006

来源: IOP

【 摘 要 】

The surface crack in flexure (SCF) is a method for the evaluation of the fracture toughness of advanced ceramics. Conventionally is practiced by using a Knoop indenter to make a very small precrack. Removal on indent and the plastically deformed zone is required before the fracture test. The purpose of this removal is to eliminate residual stresses under the Knoop impression and to obtain a semi elliptical precrack shape. In this work the influence of the variation of several experimental parameters is investigated. Fracture toughness values by the SCF method are compared with those measured using the SEVNB (single edge V-notched beam) method. The material chosen for this purpose was gas pressured sintered silicon nitride (Si3N4) containing 3wt.%Al2O3 and 3 wt.%Y2O3 (SL200B, Ceram Tec, Plochingen, Germany). The varied parameters were indentation load, orientation of the indentation crack with respect to the bending axis and the amount of material removed from the surface. Additional investigations were performed to determine the crack geometry for various indentation loads. A procedure was developed to facilitate the location and measurement of the precrack size on the fracture surfaces. The effect of measurement accuracy of the results is evaluated. The fracture toughness of specimens with a surface removal in the range suggested from ASTM C 1421 were found to agree with the results obtained from SEVNB. A surface removal below the recommendation resulted in low values of fracture toughness. Increasing the amount of surface removal moderately was found to still fit with results obtained from SEVNB. Surface removal of much more from the recommended amount leads to failure from natural flaws. Observations from serial sectioning revealed that precracks obtained from HK20 and HK30 have an irregular precrack shape with large lateral cracks. It is suggested to use HK5 and HK10 to produce semi-elliptical surface cracks.