Multi-objective optimization of process parameters of multi-step shaft formed with cross wedge rolling based on orthogonal test

2018 International Conference on Material Strength and Applied Mechanics

材料科学;力学

Han, S.T.^1,2 ; Shu, X.D.^1,2 ; Shchukin, V.^3 ; Kozhevnikova, G.^3

College of Mechanical Engineering and Mechanics, Ningbo University, Ningbo

315211, China^1

Zhejiang Provincial Key Laboratory of Part Rolling Technology, Ningbo

315211, China^2

Belarusian National Technical University, Minsk, Belarus^3

关键词: Comprehensive evaluation;    Cross-wedge rolling;    Finite element software;    High mechanical properties;    Multi-stepped shaft;    Orthogonal experiment;    Process parameters;    Provide guidances;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/372/1/012044/pdf
DOI  :  10.1088/1757-899X/372/1/012044

来源: IOP

【 摘 要 】

In order to achieve reasonable process parameters in forming multi-step shaft by cross wedge rolling, the research studied the rolling-forming process multi-step shaft on the DEFORM-3D finite element software. The interactive orthogonal experiment was used to study the effect of the eight parameters, the first section shrinkage rate π1, the first forming angle α1, the first spreading angle β1, the first spreading length L1, the second section shrinkage rate π2, the second forming angle α2, the second spreading angle β2 and the second spreading length L2, on the quality of shaft end and the microstructure uniformity. By using the fuzzy mathematics comprehensive evaluation method and the extreme difference analysis, the influence degree of the process parameters on the quality of the multi-step shaft is obtained: β2>π2L1>α1>β1>π1>α2L2. The results of the study can provide guidance for obtaining multi-stepped shaft with high mechanical properties and achieving near net forming without stub bar in cross wedge rolling.