Parametric optimization of the MVC desalination plant with thermomechanical compressor

2017 2nd International Conference on Mechatronics and Electrical Systems

机械制造;无线电电子学

Blagin, E.V.^1 ; Biryuk, V.V.^1 ; Anisimov, M.Y.^1 ; Shimanov, A.A.^1 ; Gorshkalev, A.A.^1

Heat Engineering and Heat Engines Department, Samara National Research University, Samara, Russia^1

关键词: Desalination plant;    Initial pressure;    Main parameters;    Mechanical vapour compression;    Parametric optimization;    Plant performance;    Thermo-mechanical;    Thermocompressors;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/339/1/012032/pdf
DOI  :  10.1088/1757-899X/339/1/012032

来源: IOP

【 摘 要 】

This article deals with parametric optimization of the Mechanical Vapour Compression (MVC) desalination plant with thermomechanical compressor. In this plants thermocompressor is used instead of commonly used centrifugal compressor. Influence of two main parameters was studied. These parameters are: inlet pressure and number of stages. Analysis shows that it is possible to achieve better plant performance in comparison with traditional MVC plant. But is required reducing the number of stages and utilization of low or high initial pressure with power consumption maximum at approximately 20-30 kPa.