Characteristics of diffusion zone in changing glass-metal composite processing conditions

International Conference on Mechanical Engineering, Automation and Control Systems 2017

机械制造;无线电电子学;计算机科学

Lyubimova, O.N.^1 ; Morkovin, A.V.^1 ; Andreev, V.V.^1,2

School of Engineering, Far Eastern Federal University, Vladivostok

690950, Russia^1

Institute of Machine Science and Metallurgy RAS, Komsomolsk on Amur

681005, Russia^2

关键词: Diffusion zones;    Manufacturing technologies;    Measurements of;    Mechanical characteristics;    Processing regimes;    Statistical processing;    Strength characteristics;    Technological regime;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/327/4/042066/pdf
DOI  :  10.1088/1757-899X/327/4/042066

学科分类：计算机科学（综合）

来源: IOP

【 摘 要 】

The influence of manufacturing technology on the characteristics of the glass and steel contact zone in manufacturing new structural material-glass-metal composite is studied theoretically and experimentally. Different types of structures in the contact zone and its dimensions affect the strength characteristics of the composite. Knowledge about changing the width of the glass and steel contact zone after changing such parameters of the technological regime as temperature, holding time and use of solders will allow one to control the structure and characteristics of the glass-metal composite. Experimental measurements of the width of the diffusion zone in the glass-metal composite for different regimes and their statistical processing according to the full factor experiment are presented in this article. The results of analysis of some mechanical characteristics of the diffusion zone are presented: microhardness and modulus of elasticity for samples, prepared according to different processing regimes.