Comparison of compressive strength of paving block with a mixture of Sinabung ash and paving block with a mixture of lime

TALENTA - Conference on Engineering, Science and Technology 2017

工业技术;自然科学

Hastuty, I.P.^1 ; Sembiringand Nursyamsi, I.S.^1

Departement of Civil Engineering, Universitas Sumatera Utara, Medan

20155, Indonesia^1

关键词: Adhesive materials;    Aesthetic value;    Composition ratio;    Concrete paving blocks;    Eco-friendly construction;    Maximum compressive strengths;    Road structures;    Soil-water conservation;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/309/1/012011/pdf
DOI  :  10.1088/1757-899X/309/1/012011

来源: IOP

【 摘 要 】

Paving block is one of the material used as the top layer of road structure besides asphalt and concrete paving block is usually made of mixed material such as Portland cement or other adhesive material, water, and aggregate. People nowadays prefer paving block compared to other pavement such as concrete or asphalt. Their interest toward the use of paving block increase because paving block is an eco-friendly construction which is very useful in helping soil water conservation, can be done faster, has easier installation and maintenance, has a variety of shades that increase the aesthetic value, also costs cheaper than the other. Preparation of the specimens with a mixture of Sinabung ash and a mixture of Sinabung ash and lime are implemented with a mixture ratio of cement : sand : stone ash is 1: 2 : 3. The mixture is used as a substitute material by reducing the percentage amount of the weight of the cement with the composition ratio variation based on the comparative volume category of the paving block aggregate, i.e. 0%, 5%, 10%, 15%, 20%, and 25%. The result of this research shows that the maximum compressive strength value is 42.27 Mpa, it was obtained from a mixture of 10% lime with curing time 28 days. The maximum compressive strength value which is obtained from the mixture of sinabung ash is 41.60 Mpa, it was obtained from a mixture of 15% sinabung ash. From the use of these two materials, paving blocks produced are classified as paving blocks quality A and B (350-400 Mpa) in accordance to specification from SNI 03-0691-1996.