Development of feedback-speed-control system of fixed-abrasive tool for mat-surface fabrication

8th TSME-International Conference on Mechanical Engineering

Yanagihara, K.^1 ; Kita, R.^1

National Institute of Technology, Ariake College, Higashi Hagio-Cho 150, Omuta-Shi

836-8585, Japan^1

关键词: Fixed abrasive tools;    Fixed abrasives;    Micro computer units;    Relative motion;    Relative speed;    Surface fabrication;    Surface from;    Visible light;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/297/1/012017/pdf
DOI  :  10.1088/1757-899X/297/1/012017

来源: IOP

【 摘 要 】

This study deals with the new method to fabricate a mat-surface by using fixed-abrasive tool. Mat-surface is a surface with microscopic irregularities whose dimensions are close to the wavelengths of visible light (400-700 nanometers). In order to develop the new method to fabricate mat-surface without pre-masking and large scale back up facility, utilization of fixed-abrasive tool is discussed. The discussion clarifies that abrasives in shot blasting are given kinetic energy along to only plunge-direction while excluding traverse-direction. If the relative motion between tool and work in fixed-abrasive process can be realized as that in blasting, mat-surface will be accomplished with fixed-abrasive process. To realize the proposed idea, new surface-fabrication system to which is adopted feedback-speed-control of abrasive wheel has been designed. The system consists of micro-computer unit (MPU), work-speed sensor, fixed-abrasive wheel, and wheel driving unit. The system can control relative speed between work and wheel in optimum range to produce mat-surface. Finally experiment to verify the developed system is carried out. The results of experiments show that the developed system is effective and it can produce the surface from grinding to mat-surface seamlessly.