Experimental study on the drying of natural latex medical gloves

8th TSME-International Conference on Mechanical Engineering

Chankrachang, Mano^1 ; Yongyingsakthavorn, Pisit^1 ; Tohsan, Atitaya^2 ; Nontakaew, Udomkiat^1

Department of Mechanical and Aerospace Engineering, Faculty of Engineering, King Mongkut's University of Technology North Bangkok, Bangkok

10800, Thailand^1

Department of Materials and Production Technology Engineering, Faculty of Engineering, King Mongkut's University of Technology North Bangkok, Bangkok

10800, Thailand^2

关键词: Drying time;    Initial Moisture Content;    Latex compounds;    Latex gloves;    Production capacity;    Production line;    Saving energy;    Total solid content;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/297/1/012061/pdf
DOI  :  10.1088/1757-899X/297/1/012061

来源: IOP

【 摘 要 】

The purpose of this research was to study latex film drying at 70 °C using a laboratory drying oven. Two different total solid content (TSC) latex compounds, which 45% TSC and 35% TSC were used. The undried latex films were prepared according to the common procedures used in latex gloves manufacturers, that is, by dry coagulant dipping process. The experimental results such as initial moisture content, the amount of moisture and drying time of latex films in each latex compound formula were determined. After that, the results were projected to calculate on the production capacity expand by 1 million piece/day of natural latex medical gloves. Finally, the rate of moisture entering the latex drying oven and the energy consumption of the drying oven were estimated. The results indicated that when the 35% TSC of latex compound was used. The initial moisture content of latex film was higher than 45% TSC of latex compound about 7%. The drying time of 35% TSC was longer than 45% TSC for 2.5 min and consume more energy about 10%. As a result, the 45% TSC latex compound was the better way to saving energy and managing humidity in the production line. Therefore, it was found to very useful to an approximate design length and size of actual of latex drying oven and the rate of moisture entering the oven as well.