Analysis and modeling of delamination factor in drilling of woven kenaf fiber reinforced epoxy using Box Behnken experimental design

International Conference on Advances in Manufacturing and Materials Engineering 2017

机械制造;材料科学

Suhaily, M.^1 ; Che Hassan, C.H.^2 ; Jaharah, A.G.^2 ; Afifah, M.A.^1 ; Nor Khairusshima, M.K.^1

Department of Manufacturing and Materials Engineering, International Islamic University Malaysia (IIUM), Jalan Gombak, Kuala Lumpur

53100, Malaysia^1

Department of Mechanical and Material, Faculty of Engineering and Architecture, Universiti Kebangsaan Malaysia, UKM-Bangi, Selangor

43600, Malaysia^2

关键词: Analysis and modeling;    Box-Behnken experimental design;    Delamination factor;    Drilling operation;    Drilling parameters;    Fiber reinforced epoxy;    Fiber reinforced epoxy composites;    Reinforced epoxy;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/290/1/012033/pdf
DOI  :  10.1088/1757-899X/290/1/012033

学科分类：材料科学（综合）

来源: IOP

【 摘 要 】

In this research study, it presents a comprehensive mathematical model for correlating the influences of drilling parameters on the delamination factor during the drilling of woven kenaf fiber reinforced epoxy composite laminates using the Box Behnken experimental design. The purpose of this study is to investigate the influence of drilling parameters such as cutting speed, feed rate and drill sizes on the delamination produced when drilling woven kenaf reinforced epoxy composite using the non-coated HSS drill bits. The damage generated on the woven kenaf reinforced epoxy composite laminates were observed both at the entrance and exit surface during the drilling operation. The experiments were conducted according to the Box Behnken experimental designs.