Design and Simulation Plant Layout Using Systematic Layout Planning

10th International Seminar on Industrial Engineering and Management "Sustainable Development In Industry and Management"

Suhardini, D.^1 ; Septiani, W.^1 ; Fauziah, S.^1

Department of Industrial Engineering, Faculty of Industrial Technology, Trisakti University, Jakarta

11440, Indonesia^1

关键词: Cross-traffic;    Design and simulation;    Evaluation and selections;    Increase productions;    Material handling costs;    Production capacity;    Simulation;    Systematic layout planning;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/277/1/012051/pdf
DOI  :  10.1088/1757-899X/277/1/012051

来源: IOP

【 摘 要 】

This research aims to design the factory layout of PT. Gunaprima Budiwijaya in order to increase production capacity. The problem faced by this company is inappropriate layout causes cross traffic on the production floor. The re-layout procedure consist of these three steps: analysing the existing layout, designing plant layout based on SLP and evaluation and selection of alternative layout using Simulation Pro model version 6. Systematic layout planning is used to re-layout not based on the initial layout. This SLP produces four layout alternatives, and each alternative will be evaluated based on two criteria, namely cost of material handling using Material Handling Evaluation Sheet (MHES) and processing time by simulation. The results showed that production capacity is increasing as much as 37.5% with the addition of the machine and the operator, while material handling cost was reduced by improvement of the layout. The use of systematic layout planning method reduces material handling cost of 10,98% from initial layout or amounting to Rp1.229.813,34.