The durability of concrete containing recycled tyres as a partial replacement of fine aggregate

Global Congress on Construction, Material and Structural Engineering 2017

材料科学;土木建筑工程

Senin, Mohamad Syamir^1 ; Shahidan, Shahiron^1 ; Leman, Alif Syazani^1 ; Othman, Nurulain^1 ; Shamsuddin, Shamrul-Mar^1 ; Ibrahim, M.H.W.^1 ; Mohd Zuki, S.S.^1

Jamilus Research Center-Sustainable Construction, Faculty of Civil and Environmental Engineering, Universiti Tun Hussein Onn Malaysia, Malaysia^1

关键词: Absorption abilities;    Careful management;    Coarse aggregates;    Concrete samples;    Durability of concretes;    Fine aggregates;    Partial replacement;    Waste rubber;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/271/1/012075/pdf
DOI  :  10.1088/1757-899X/271/1/012075

来源: IOP

【 摘 要 】

Nowadays, uncontrolled disposal of waste materials such as tyres can affect the environment. Therefore, careful management of waste disposal must be done in order to conserve the environment. Waste tyres can be use as a replacement for both fine aggregate and coarse aggregate in the production of concrete. This research was conducted to assess the durability of concrete containing recycled tyres which have been crushed into fine fragments to replace fine aggregate in the concrete mix. This study presents an overview of the use of waste rubber as a partial replacement of natural fine aggregate in a concrete mix. 36 concrete cubes measuring 100mm × 100mm × 100mm and 12 concrete cubes measuring 150mm × 150mm × 150mm were prepared and added with different percentages of rubber from recycled tyres (0%, 3%, 5% and 7%) as fine aggregate replacement. The results obtained show that the replacement of fine aggregate with 7% of rubber recorded a compressive strength of 43.7MPa while the addition of 3% of rubber in the concrete sample recorded a high compressive strength of 50.8MPa. This shows that there is a decrease in the strength and workability of concrete as the amount of rubber used a replacement for fine aggregate in concrete increases. On the other hand, the water absorption test indicated that concrete which contains rubber has better water absorption ability. In this study, 3% of rubber was found to be the optimal percentage as a partial replacement for fine aggregate in the production of concrete.