Mechanical Properties of Graphene-Rubber Nanocomposites

International Conference of Applied Science and Technology for Infrastructure Engineering

土木建筑工程;材料科学

Anhar, N.A.M.^1 ; Ramli, M.M.^1,2 ; Hambali, N.A.M.A.^1 ; Aziz, A.A.^3 ; Mat Isa, S.S.^1,2 ; Danial, N.S.^1,2 ; Abdullah, M.M.A.B.^2

School of Microelectronic Engineering, Universiti Malaysia Perlis, Pauh Putra Campus, Perlis-Arau

02600, Malaysia^1

Center of Excellence Geopolymer and Green Technology (CEGeoGTech), School of Materials Engineering, Universiti Malaysia Perlis (UniMAP), P.O. Box 77, D/A Pejabat Pos Besar, Kangar, Perlis, Malaysia^2

High Value Added Rubber Products and Nanostructured Materials, Technology and Engineering Division, Rubber Research Institute of Malaysia, Malaysian Rubber Board, Selangor, Sungai Buloh

47000, Malaysia^3

关键词: Epoxidized natural rubber;    Instron;    Optimum loading;    Powder nanocomposites;    Prevulcanized natural rubber;    Reduced graphene oxides (RGO);    Rubber nanocomposites;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/267/1/012009/pdf
DOI  :  10.1088/1757-899X/267/1/012009

来源: IOP

【 摘 要 】

This research focused on development of wearable sensor device by using Prevulcanized Natural Rubber (PV) and Epoxidized Natural Rubber (ENR 50) latex incorporated with graphene oxide (GO), graphene paste, graphene powder and reduced graphene oxide (rGO) powder. The compounding formulation and calculation were based on phr (parts per hundred rubber) and all the samples were then tested for mechanical properties using Instron 5565 machine. It was found that the sonication effects on tensile strength may have better quality of tensile strength compared to non-sonicated GO. For PV incorporate GO, the optimum loading was best determined at loading 1.5 phr with or without sonication and similar result was recorded for PV/G. For ENR 50 incorporate graphene paste and rGO powder nanocomposite shows the best optimum was at 3.0 phr with 24 hours' sonication.