Quality of Metal Deposited Flux Cored Wire With the System Fe-C-Si-Mn-Cr-Mo-Ni-V-Co

International Scientific-Practical Conference: Innovations in Fuel and Energy Complex and Mechanical Engineering 2017

能源学;机械制造

Gusev, Aleksander I.^1 ; Kozyrev, Nikolay A.^1 ; Osetkovskiy, Ivan V.^1 ; Kryukov, Roman E.^1 ; Kozyreva, Olga A.^2

Siberian IndustrialStateUniversity, Kemerovo Region, Kirova street, 42, Novokuznetsk

654007, Russia^1

KemerovoStateUniversity, Krasnay street, 6, Kemerovo

650000, Russia^2

关键词: Aluminum production;    Approximation errors;    Calculated values;    Chemical compositions;    Laboratory conditions;    Multivariate correlation;    Non-metallic inclusions;    Retained austenite;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/253/1/012008/pdf
DOI  :  10.1088/1757-899X/253/1/012008

来源: IOP

【 摘 要 】

Studied the effect of the introduction of vanadium and cobalt into the charge powder fused wire system Fe-C-Si-Mn-Cr-Ni-Mo-V, used in cladding assemblies and equipment parts and mechanisms operating under abrasive and abrasive shock loads. the cored wires samples were manufactured in the laboratory conditions and using appropriate powder materials and as a carbonfluoride contained material were used the dust from gas purification of aluminum production, with the following components composition, %: Al2O3= 21-46.23; F = 18-27; Na2O = 8-15; K2O = 0.4-6; CaO = 0.7-2.3; Si2O = 0.5-2.48; Fe2O3= 2.1-3.27; C = 12.5-30.2; MnO = 0.07-0.9; MgO = 0.06-0.9; S = 0.09-0.19; P = 0.1-0.18. Surfacing was produced on the St3 metal plates in 6 layers under the AN-26C flux by welding truck ASAW-1250. Cutting and preparation of samples for research had been implemented. The chemical composition and the hydrogen content of the weld metal were determined by modern methods. The hardness and abrasion rate of weld metal had been measured. Conducted metallographic studies of weld metal: estimated microstructure, grain size, contamination of oxide non-metallic inclusions. Metallographic studies showed that the microstructure of the surfaced layer by cored wire system Fe-C-Si-Mn-Cr-Mo-Ni-V-Co is uniform, thin dendrite branches are observed. The microstructure consists of martensite, which is formed inside the borders of the former austenite grain retained austenite present in small amounts in the form of separate islands, and thin layers of δ-ferrite, which is located on the borders of the former austenite grains. Carried out an assessment the effect of the chemical composition of the deposited metal on the hardness and wear and hydrogen content. In consequence of multivariate correlation analysis, it was determined dependence to the hardness of the deposited layer and the wear resistance of the mass fraction of the elements included in the flux-cored wires of the system Fe-C-Si-Mn-Cr-Mo-Ni-V-Co. The calculated value of the average approximation error suggests that the dependence is adequate and can be used to determine the resulting indicators. These dependencies can be used to predict the hardness of the deposited layer and its wear resistance while changing the chemical composition of the weld metal.