Behavior of Sn-0.7Cu-xZn lead free solder on physical properties and micro structure

1st Nommensen International Conference on Technology and Engineering

Siahaan, Erwin^1

Mechanical Engineering Department, School of Engineering, Tarumanagara University, Jakarta, Indonesia^1

关键词: Differential scanning calorimeters;    Electronic application;    Environmental hazards;    Eutectic composition;    Industrial workers;    Research communities;    Soldering materials;    Traditional industry;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/237/1/012044/pdf
DOI  :  10.1088/1757-899X/237/1/012044

来源: IOP

【 摘 要 】

The issues to substitute Tin-Lead Solders is concerning the health and environmental hazards that is caused by lead, and also legislative actions around the world regarding lead toxicity, which has prompted the research community to attempt to replace solder alloys for the traditional Sn-Pb alloys lead which has been used by industrial worker throughout history because it is easily extracted and refined at a relatively low energy cost and also has a range of useful properties. Traditional industry lead has been used in soldering materials for electronic applications because it has low melting point and a soft, malleable nature, when combined with tin at the eutectic composition which causes the alloy to flow easily in the liquid state and solidifies over a very small range of temperature. One of the potential candidate to replace tin-lead solder is Sn-Cu-Zn eutectic alloy as it has a lower melting temperature. Consequently, it is of interest to determine what reactions can occur in ternary systems derived from the Sn-Cu-Zn eutectic. One such system is Sn-0.7Cu-xZn. The specimen was elaborated on physical properties. The chemical content was analyzed by using Shimadzu XRD and melting point was analyzed by using Differential Scanning Calorimeter ( DSC ). The results has shown that the highest addition of Zinc content (15%Zn) will decrease the melting temperatur to 189°C compared to Sn-Pb at 183°C Increasing the amount of Zn on Sn0.7Cu-xZn alloys will decrease Cu3Sn intermetallic coumpound.