2D and 3D impellers of centrifugal compressors _ advantages, shortcomings and fields of application

10th International Conference on Compressors and their Systems

Galerkin, Y.^1 ; Reksrin, A.^1 ; Drozdov, A.^1

RandD Laboratory Gas Dynamics of Turbo Machines, Peter the Great St. Petersburg Polytechnic University, Polytechnical st. 29, St.Petersburg, Russia^1

关键词: Design flow rate;    Efficiency levels;    Flow rate coefficients;    High speed drives;    Higher efficiency;    Loss coefficients;    Simplified equations;    Specific problems;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/232/1/012040/pdf
DOI  :  10.1088/1757-899X/232/1/012040

来源: IOP

【 摘 要 】

The simplified equations are presented for calculation of inlet dimensions and velocity values for impellers with three-dimensional blades located in axial and radial part of an impeller (3D impeller) and with two-dimensional blades in radial part (2D). Considerations concerning loss coefficients of 3D and 2D impellers at different design flow rate coefficients are given. The tendency of reduction of potential advantages of 3D impellers at medium and small design flow rate coefficients is shown. The data on high-efficiency compressors and stages with 2D impellers coefficients designed by the authors are presented. The reached efficiency level of 88 - 90% makes further increase of efficiency by the application of 3D impellers doubtful. CFD-analysis of stage candidates with medium flow rate coefficient with 3D and 2D impellers revealed specific problems. In some cases the constructive advantage of a 2D impeller is smaller hub ratio. It makes possible the reaching of higher efficiency. From other side, there is a positive tendency of gas turbine drive RPM increase. 3D impellers have no alternative for stages with high flow rate coefficients matching high-speed drive.