Reduction of the suction losses through reed valves in hermetic reciprocating compressors using a magnet coil

10th International Conference on Compressors and their Systems

Hopfgartner, J.^1 ; Posch, S.^1 ; Zuber, B.^1 ; Almbauer, R.^1 ; Krischan, K.^1 ; Stangl, S.^2

Graz University of Technology, Graz

8010, Austria^1

Secop Austria GmbH, Fürstenfeld

8280, Austria^2

关键词: Bottom dead centres;    Compression stroke;    Electromagnetic coils;    Flow resistance;    Hermetic reciprocating compressor;    Magnetic force;    Suction valves;    Thermodynamic loss;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/232/1/012034/pdf
DOI  :  10.1088/1757-899X/232/1/012034

来源: IOP

【 摘 要 】

Reed valves are widely used in hermetic reciprocating compressors and are responsible for a large part of the thermodynamic losses. Especially, the suction valve, which is opened nearly during the whole suction stroke, has a big potential for improvement. Usually, suction valves are opened only by vacuum created by the moving piston and should be closed before the compression stroke starts to avoid a reversed mass-flow through the valve. Therefore, the valves are prestressed, which results on the other hand in a higher flow resistance. In this work, a suction valve is investigated, which is not closed by the preload of the valve but by an electromagnetic coil located in the suction muffler neck. Shortly before the piston reaches its bottom dead centre, voltage is applied to the coil and a magnetic force is generated which pulls the valve shut. Thereby, the flow resistance through the valve can be reduced by changing the preload on the reed valve because it is no longer needed to close the valve. The investigation of this adapted valve and the electromagnetic coil is firstly done by numerical simulations including fluid structure interactions of the reed valves of a reciprocating compressor and secondly by experiments made on a calorimeter test bench.