Influence of electromagnetic field on metal cutting in turning operation of AISI 1018 low carbon steel

International Technical Postgraduate Conference

Nadia, J.N.^1 ; Aaron, F.^1 ; Azuddin, M.^1

Centre of Product Design and Manufacture (CPDM), Department of Mechanical Engineering, Faculty of Engineering, University of Malaya, Kuala Lumpur, Malaysia^1

关键词: Cutting forces;    Dry condition;    Feed forces;    Influence of electromagnetic field;    Machining force;    Radial forces;    Taguchi approach;    Turning operations;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/210/1/012066/pdf
DOI  :  10.1088/1757-899X/210/1/012066

来源: IOP

【 摘 要 】

The effects of magnetic field on the machining force and tool wear in turning operation has been investigated. AISI 1018 low carbon steel used during machining as it is generally used in industry. The present and absent of the magnetic field during machining in dry condition was studied, and has been analysed. Taguchi approach has been used when designing the experiment. The results shown in this study related to the machining force and tool wear. The experimental results shown that when magnetic field has been applied, the machining force in turning operation such as radial force (Fr), feed force (Ff), and cutting force (Fc) gave higher results as compared to the absent of magnetic field. As for the tool wear, the results shown that the tool life is getting longer when the magnetic field has been applied which has been proven by the previous studies done before.