The Effect of Temperature in Induction Surface Hardening on the Distortion of Gear

4th International Conference on Advanced Materials Science and Technology

Guterres, N.F.D.S.^1 ; Rusnaldy^2 ; Widodo, A.^2

Department of Mechanical Engineering, Dili Institute of Technology, Aimutin Street, Timor Leste, Dili, Timor-leste^1

Department of Mechanical Engineering, University of Diponegoro, Prof. Soedharto Street, Tembalang, Semarang

50275, Indonesia^2

关键词: Effect of temperature;    Geometric distortion;    Induction hardening;    Induction surface hardening;    Manufacturing process;    Microstructure analysis;    S45C;    Surface hardening;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/202/1/012092/pdf
DOI  :  10.1088/1757-899X/202/1/012092

来源: IOP

【 摘 要 】

One way to extend the lifetime of gear is minimizing the distortion during the manufacturing process. One of the most important processes in gear manufacturing is induction surface hardening. Induction hardening causes a geometric distortion in gears. This study aimed to analyze the distortion of the gear after induction surface hardening. The material of gear that used in this research is S45C, and it was designed with the a module (m) of 1.75, and 29 teeth (z). In the experiment, the gear was heat-treated using induction hardening at variations of temperatures of 820, 880, and 920 °C with holding time was 35, 45, and 55 s, respectively. Then the gear quenched in water at room temperature. The microstructure analysis was conducted to explore the phase change in gear teeth. Hardness test was also performed on the gear using Rockwell test, and finally, the gear dimension was evaluated. The results showed that the hardness of gear at the teeth surface was 64.9 HRC at the case depth of 5 mm is proper to be used. The microstructure of gear at the surface is martensitic, and the deeper area is pearlite. Gear distortion of all teeth with average thickness was reduced and the highest value was 1.593% at the austenite temperature of 820 °C. While the highest reduction was produced at the temperature of 920 °C and generated the highest shrinkage. The induction surface hardening of the gear was not high, and the highest distortion was found in the outside diameter.