Improving machining performance using alumina powder-added dielectric during electrical discharge machining (EDM)

3rd International Conference on Mechanical, Automotive and Aerospace Engineering 2016

机械制造;无线电电子学;航空航天工程

Ali Khan, Ahsan^1 ; Abu Bakar, Marina Binti^1 ; Faizi Al-Hazza, Muataz Hazza^1 ; Che Daud, Mohd Radzi Haji^1 ; Mohiuddin, A.K.M.^2

Department of Manufacturing and Materials Engineering, International Islamic University Malaysia, Jalan Gombak, Kuala Lumpur

53100, Malaysia^1

Department of Mechanical Engineering, International Islamic University Malaysia, Jalan Gombak, Kuala Lumpur

53100, Malaysia^2

关键词: Electrical discharge machining;    Full factorial experiment;    Machining characteristics;    Machining parameters;    Machining performance;    Material removal rate;    Surface finishes;    Surface roughness (Ra);   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/184/1/012040/pdf
DOI  :  10.1088/1757-899X/184/1/012040

学科分类：航空航天科学

来源: IOP

【 摘 要 】

Alumina powder was added to dielectric fluid during Electrical discharge machining (EDM) of AISI 304 steel. The main machining parameters of current (A), tool diameter (mm) and powder concentration (g/L) were chosen to determine the EDM machining characteristics of material removal rate (MRR), tool wear rate (TWR) and surface roughness (Ra). This work adopted two-level full factorial experiments. The significant factors that affect the MRR and tool TWR are current, tool diameter and powder concentration. The MRR increases when the current and tool diameter are higher. The presence of powder concentration also increases the MRR. The higher current used and the presence of powder concentration increase the TWR. Meanwhile, a smaller tool diameter gives higher value of TWR. Current and powder concentration are the significant factors to determine the surface roughness of work surfaces. Higher current applied gives high surface roughness, but higher powder concentration gives improved surface finish.