Characterization of Nylon 6 Nano Fiber/E-Glass Fiber Reinforced Epoxy Composites

International Conference on Emerging Trends in Engineering Research

工业技术;材料科学

Vinod Kumar, T.^1 ; Chandrasekaran, M.^1 ; Santhanam, V.^2 ; Udayakumar, N.^2

Department of Mechanical Engineering, Vels University, Chennai, Tamil Nadu, India^1

Department of Mechanical Engineering, Rajalakshmi Engineering College, Chennai, Tamil Nadu, India^2

关键词: Continuous fibers;    E-glass fibers;    Fiber reinforced epoxy composites;    Hand lay-up;    Nylon-6;    Process parameters;    Thermoplastic polymer;    Volume ratio;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/183/1/012002/pdf
DOI  :  10.1088/1757-899X/183/1/012002

来源: IOP

【 摘 要 】

In the paper thermoplastic polymer Nylon-6 is generated in the form of Nanofibers by using an electro spinning method, and concentration of a solution is 4% as a constant then, by varying the process parameters such as flow rate (0.8 ml/hr, 1ml/hr and 1.2 ml/hr) of the solution. The results indicated Nanofibers with 4% concentration and 1 ml/hr produced optimum fibers due to continuous fiber formation. Composites Plates are fabricated by using a Hand lay-up method with different volume fraction (0.5, 1, 2 % v/v) of Nanofibers ratio. Then, the optimum Nanofibers volume ratio (2 % v/v) is reinforced with E-glass fibers and epoxy resin as a matrix. In order to find Nanofibers effect, Mechanical properties like (Tensile, Flexural and Impact) is performed and evaluated.