The simulation of the workpiece and saw teeth heating during the high-speed cutting process

International Conference on Mechanical Engineering, Automation and Control Systems 2016

机械制造;无线电电子学;计算机科学

Gurevich, L.M.^1 ; Bannikov, A.I.^1 ; Pronichev, D.V.^1 ; Novikov, R.E.^1 ; Serov, A.G.^1

Volgograd State Technical University, Lenin Ave., 28, Volgograd

400005, Russia^1

关键词: Deform 3D software;    Distribution of temperature;    High speed cutting;    Metallographic analysis;    Saw-tooth;    Workpiece;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/177/1/012082/pdf
DOI  :  10.1088/1757-899X/177/1/012082

学科分类：计算机科学（综合）

来源: IOP

【 摘 要 】

The paper presents the result of the simulation of the workpiece and saw teeth heating during high-speed cutting using the Deform 3D software package. The distribution of temperature and stressing fields during the high-speed cutting process was obtained. The investigation was confirmed by metallographic analysis, and it shows good convergence of simulation results with practical results for the temperature fields.