Modal testing circuit board assembly of an electronic apparatus by laser vibrometry

International Conference and Youth Scientific School on "Materials and Technologies of New Generations in Modern Materials Science"

Krasnoveikin, V.A.^1 ; Smolin, I Yu^1,2,3 ; Druzhinin, N.V.^1 ; Kolubaev, E.A.^1 ; Derusova, D.A.^1

Institute of Strength Physics and Materials Science, SB RAS, 2/4 pr. Akademicheskii, Tomsk

634021, Russia^1

Tomsk State University, 36 Lenin Ave., Tomsk

634050, Russia^2

Tomsk Polytechnic University, 30 Lenin Ave., Tomsk

634050, Russia^3

关键词: Control techniques;    Eigen frequencies;    Electronic apparatus;    Operating capacity;    Rapid generations;    Vibration amplification;    Vibration displacements;    Vibration velocity;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/156/1/012005/pdf
DOI  :  10.1088/1757-899X/156/1/012005

来源: IOP

【 摘 要 】

The operating capacity and service life of printed circuit boards in various electronic equipment and devices depends on their ability to resist vibroacoustic loads, including vibration and acoustic noises. In this paper, non-contact laser vibrometry has been applied to perform the modal analysis of a circuit board assembly in order to identify its vulnerable spots and to find solutions to protect the assembly from external vibroacoustic loads. A broadband periodic chirp signal was used to excite vibration, which enabled a rapid generation of results. The paper provides data on eigenfrequencies, vibration velocity fields, and vibration displacement profiles. Frequency ranges have been determined in which eigenfrequencies with the highest vibration amplification lie. The obtained data can be used to develop a quality control technique for printed circuit boards and to optimize their construction as early as the design stage.