The automated system for technological process of spacecraft's waveguide paths soldering

7th International Scientific and Research Conference "Topical Issues in Aeronautics and Astronautics"

航空航天工程

Tynchenko, V.S.^1 ; Murygin, A.V.^1 ; Emilova, O.A.^1 ; Bocharov, A.N.^1 ; Laptenok, V.D.^1

Reshetnev Siberian State Aerospace University, 31, Krasnoyarsky Rabochy Av., Krasnoyarsk

660037, Russia^1

关键词: Automated process control;    Automated systems;    Changing parameter;    Information control systems;    Measurement equipment;    Soldering process;    System operation;    Technological process;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/155/1/012007/pdf
DOI  :  10.1088/1757-899X/155/1/012007

学科分类：航空航天科学

来源: IOP

【 摘 要 】

The paper solves the problem of automated process control of space vehicles waveguide paths soldering by means of induction heating. The peculiarities of the induction soldering process are analyzed and necessity of information-control system automation is identified. The developed automated system makes the control of the product heating process, by varying the power supplied to the inductor, on the basis of information about the soldering zone temperature, and stabilizing the temperature in a narrow range above the melting point of the solder but below the melting point of the waveguide. This allows the soldering process automating to improve the quality of the waveguides and eliminate burn-troughs. The article shows a block diagram of a software system consisting of five modules, and describes the main algorithm of its work. Also there is a description of the waveguide paths automated soldering system operation, for explaining the basic functions and limitations of the system. The developed software allows setting of the measurement equipment, setting and changing parameters of the soldering process, as well as view graphs of temperatures recorded by the system. There is shown the results of experimental studies that prove high quality of soldering process control and the system applicability to the tasks of automation.