Hyperplasticity effect under magnetic pulse straightening of dual phase steel

4th International Conference on Advanced Composites and Materials Technologies for Arduous Applications

Falaleev, A.P.^1 ; Meshkov, V.V.^2 ; Shymchenko, A.^2

Peter the Great St.Petersburg Polytechnic University, Russia^1

Sevastopol State University, Russia^2

关键词: Current strength;    Dual-phase steel;    Electrical current;    Gravity forces;    Hyperplasticity;    Material deformation;    Mechanical analysis;    Sheet metal parts;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/153/1/012014/pdf
DOI  :  10.1088/1757-899X/153/1/012014

来源: IOP

【 摘 要 】

An investigation of the behaviour of dual phase steel parts during straightening operations, by means of magnetic pulse treatment, is presented. The mechanical analysis of magnetic-pulse treatment for the straightening of thin-walled sheet metal parts produced from dual phase steel was performed, taking into account the effect of hyperplasticity under the influence of the magnetic field. Taking account of the causes of the hyperplasticity and thus the increase of material plasticity, it has been shown that the magnetic impulse gravity can be adjusted by controlling the operation modes. The dependence of the generated magnetic impulse gravity force on the electrical current strength inducted in this part was explored and used for analysis of the magnetic pulse straightening of dual phase steel part. Experimental results were obtained for thin-walled sheet metal part produced from dual phase steel DP 780. The results are used to demonstrate the material deformation under the influence of magnetic impulse gravity force considering the increase of material plasticity. The dependence of relative material deformation on the generated magnetic impulse gravity as well as on the current strength induced in this material was obtained and analyzed.