Conversion of the exhaust emission results obtained from combustion engines of heavy-duty vehicles

Scientific Conference on Automotive Vehicles and Combustion Engines 2016

Merkisz, J.^1 ; Pielecha, J.^1

Poznan University of Technology, 3 Piotrowo Street, Poznan

60-965, Poland^1

关键词: Combustion engines;    Emission values;    Exhaust emission;    Heavy duty;    Heavy duty vehicles;    Per unit;    Pollutant emission;    Road vehicles;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/148/1/012078/pdf
DOI  :  10.1088/1757-899X/148/1/012078

来源: IOP

【 摘 要 】

The use of internal combustion engines as the drive for heavy-duty vehicles forces these engines to be tested on an engine dynamometer. Thus, these engines operate under forced conditions, which are significantly different from their actual application. To assess the ecology of such vehicles (or more accurately the engine alone) the emission of pollution per unit of work done by the engine must be determined. However, obtaining the results of unit emissions (expressed in grams of the compound per a unit of performed work) does not give the grounds for determining the mass of pollutants on a given stretch of the road travelled by the vehicle. Therefore, there is a need to change the emission value expressed in units referenced to the engine work into a value of road emissions. The paper presents a methodology of determining pollutant emissions of heavy-duty road vehicles on the basis of the unit emissions, as well as additional parameters determined on the basis of the algorithm presented in the article. A solution was obtained that can be used not only for heavy-duty vehicles, but was also extended to allow use for buses.